okuma sabiki utg rod

Okuma Sabiki UTG rod

DESIGNED for jigging sabiki rigs when gathering bait, with the design allowing the rig to be wound inside the rod to minimises snagging and tangling when not in use, the Okuma Sabiki UTG rod has been built from the ground up to overcome the shortcomings of other sabiki rods that have been pointed out to Okuma by frustrated anglers.

A slight increase in length to 7’3” allows more brands of jigs to be wound completely inside the rod, while the slimmer design increases the action of the rod and in turn the fish-catching action of
the jig. Designed to be used with either spin or overhead reels, the Sabiki UTG is a two-piece blank for easy storage, with a butt join rather than the traditional join above the bottom line guide that can make line feeding difficult and cause snagging of swivels on sabiki jigs.

The tip of the Sabiki UTG is also uniquely designed to remove the snagging that occurs both on the outside of the tip and internally where the tip joins the rod blank on traditional sabiki rods.

Keep your sabiki jigs tangle-free, securely stowed and ready to go with the Okuma Sabiki UTG rod.

• Reduces tangles and simplifies sabiki storage;
• Improved design including line feeder and tip feeder;
• Two-piece design with butt join;
• Additional length to suit more sabiki brands; and
• Quality components and EVA grips.

Available now with a SRP of $79.90.

www.okuma.com.au

It's only fair to share...Share on Facebook
Facebook
Tweet about this on Twitter
Twitter
Print this page
Print
Email this to someone
email

About Bush 'n Beach Fishing mag

Check Also

fish rescued nsw

Threatened fish rescued across NSW

RELOCATIONS of threatened fish have been conducted by the NSW Department of Primary Industries from …

Leave a Reply

Your email address will not be published. Required fields are marked *